Large format laser engraving, I like it very much
The large working format of the SpiderX1 was a huge surprise, it made my creations even more impressive, and I also found a very cheap and fast implementation.
1. Prepare a large enough corrugated cardboard, I found it is 90cm-150cm
2. Use LightBurn to set the format 80cm-200cm, and import the DXF file
3. The graphics are big enough, I am 80cm-46cm.
4. After my test, the engraving parameters can be set to 1000mm/min, and the power is set to 100% (I am a 20W laser). It can be done in about 6 minutes, very fast, I like it very much
5. After finishing, spray black paint on the surface. It is more convenient to use self-drawing. After drying, my creations are ready. I never thought my job could be done so easily and quickly. this is great
该资源需登录后下载
去登录
Comment List(15)
Ned
2024.3.13 19:03
I know this web page provides quality depending content and additional information, is there any other web site which presents these stuff in quality?
Brentyn
2024.3.13 19:03
We are a group of volunteers and starting a new scheme in our community.
Your site provided us with valuable info to work on. You’ve done an impressive job and our whole community will be grateful to you.
Chet
2024.3.13 19:03
What i don’t understood is in fact how you’re
no longer actually much more neatly-preferred than you might be right now.
You’re very intelligent. You know thus significantly in the case of this matter,
produced me in my opinion consider it from numerous varied angles.
Its like women and men don’t seem to be fascinated unless it’s
something to do with Lady gaga! Your individual stuffs excellent.
At all times care for it up!